Assembling your new RC car with Soft Bullet Gun is the first step towards hours of fun and adventure. In this blog, we'll guide you through the simple but satisfying process of assembling your car so you can get started quickly. Find out how to get your RC car ready for action with a few simple steps, from unpacking to the moment you take the remote control in your hands.
Step 1. Unpack box.
Unpack the box and check that all parts are present.
Step 2. Insert battery in remote control
Open the battery compartment with the screwdriver. Insert 2x A4 standard batteries into the remote control.
Step 3. Lithium battery charging
Before first use, charge the lithium battery with the supplied USB charging cable (about 2 hours). The battery is fully charged when the LED indicator lights no longer illuminate.
Step 4. Insert lithium battery into chassis
Insert the 7.4V lithium battery into the chassis of the radio control machine with soft balls
Step 5. Fill water tank
Fill the water tank carefully and only with the press bottle! Insert the cap firmly.
Step 6. Installing wheels
Place the four wheels on the chassis of the radio control machine with soft balls by clicking them into place.
Step 7. Preparing the magazine
Remove the magazine from the emitter by pushing it backwards and then removing it with an angle.
Step 8. Load soft bullets
Load the 12 soft bullets into the magazine. Make sure the bullets are loaded correctly. Press them firmly so that they do not protrude above the magazine.
Step 9. Replace the magazine
Slide the magazine back into the ejector, again at an angle and back first. Push the front of the magazine down until you hear a click. Still not succeeding? Our colleague David explains how to do this in a video!
Step 10. Insert emitter
Place the emitter on the chassis of the radio control machine with soft balls.
Step 11. Switch on
Switch on the RC car by turning the button on the back of the chassis to ON and switching on the remote control. The remote control and the RC car will now connect automatically. Ready set go!
Step 12. Switch on
Switch on the RC car by turning the button on the back of the chassis to ON and switching on the remote control. The remote control and the RC car will now connect automatically. Ready set go!
